Vent Axia Kinetic Highflow

Description

The Lo-Carbon Sentinel Kinetic High Flow is a new heat recovery unit with the highest high performance for large houses, student accommodation and small commercial applications, this top-quality unit has every conceivable option for control with proven durability and performance

Suitable for houses up to 350 m2 and meets the latest requirements of the Building Regulations ADF and ADL for whole house system ventilation:

KEY FEATURES:

• Vent Axia Heat recovery unit
• Suitable for houses up to 350 m2
• Up to 91% heat recovery
• Extra low energy use
• Mechanical summer by-pass
• Internal humidity sensor
• Digital control
• 5 Year warranty
• Vertical or horizontal connections
• Left or right-hand configuration
• Weight: 34kg
• Dimensions (HxLxW): 635 x 785 x 550 (mm)
• Duct dia: 180/200 mm

Filtration

2 x G4 with the option of a M5 pollen intake filter

Controllability

The Lo-Carbon Sentinel Kinetic High Flow has 3 fully adjustable speeds and a purge setting (maximum flow). Provided with the unit is a digital controller that can be used to pre-set the speeds to any required airflow within the performance range

Boost can be achieved with almost any type of sensor or switch including momentary

Integral Humidity Sensor

The integral humidity sensor increases speed in proportion to relative humidity levels, saving energy and reducing noise. The sensor also reacts to small but rapid increases in humidity, even if the normal trigger threshold is not reached. This unique feature ensures adequate ventilation, even for the smallest wet room. The night time relative humidity setback feature suppresses nuisance tripping as humidity gradually increases with falling temperature

Construction

The outer enclosure is constructed of PVC with the inner body being constructed of EPP

Motors

The unit has 2 x low energy, high efficiency EC/DC motors

Installation
Spigot Options – The combination of spigot options allows installation in confined locations. If vertical and horizontal connection is required on the same outlet/inlet, additional spigots can be supplied. The condensate drain can be taken out through the back, side or bottom of the unit. Using the fittings supplied, the final condensate connection is made outside the unit and can be completed after installation

ACCESSORIES:

In addition to a choice of compatible ducting systems a full range of controls, sensors, in-line silencers, floor/wall/ceiling inlet and outlet diffusers are available to complete the installation.